Description of connectors on the back of the extended version of the on-board computer.
8-pin connector connection:
- A standard car relay must be connected to control the daytime running lights and the immobilizer. For daytime running lights, connect the relay control coil (terminals 85 and 86) to the DAYLIGHT and + 12V outputs. For immobilizer for IMMOBILISER and + 12V outputs. The switched output is on terminals 30 and 87. For daytime running lights, connect the switched output to the prepared cable harness. It is usually located above the fuse box. If there is no preparation, we will make a connection at the light control connector. For the immobilizer, the switched output is used to block an important engine system.
Automotive relay
- We can also use a car relay to control the air conditioning, but in this case any switching relay with a 12V coil, which we connect to the CLIMA and + 12V outputs, is quite sufficient. Installation varies depending on the type of air conditioning in the vehicle (Behr or Delphi) and is described in the on-board computer installation manual.
- The internal temperature sensor is of the NTC type and is connected to the input marked INTERNAL SENSOR and INTERNAL SENSOR GND.
Internal temperature sensor
4-pin connector connection:
- The 4-pin connector is designed for connecting up to two resistance sensors. There are two ways to measure:
- NTC sensor.
- Linear input.
- Connect the resistance sensor to the input marked INPUT A/D1 (white wire) and GND A/D1 (brown/white wire) , or INPUT A/D2 (red wire) and GND A/D2 (brown/red wire). The configuration of the inputs is described in the operating instructions (Service Menu / A/D Input Settings).
5-pin connector connection:
- The 5-pin connector is intended for connecting an external module (serial line). Optimally a module from the wide “Arduino” family. Allows you to display your own information anywhere on the screen. The conditions and settings of the serial line are shown in the application example. The color marking of the wires usual for the Arduino was used for the power supply.
- Black wire: GND
- Red wire: +12V
- Yellow wire: Data
- Important note: The connection of the external module should always be made by an expert who is familiar with electronic systems. The serial line communicates on a 5 volt level with a direct connection to the Arduino module. Therefore, care must be taken to ensure that the input voltage never exceeds 5V. Otherwise the on-board computer may be damaged. We always connect the module to the on-board computer when the key is removed from the ignition switch. The power supply of the module is in operation after activation of the key and is protected by an internal PTC fuse of 100mA.
RELIABLE DELIVERY










